Grease Fitting Locations - Grease Every 10 Hours (or Daily)
1. Main Auger Thrust Washer
2. Main Auger Front Bearing
3. Front Auger Slide Plate (4 Remote Zerks)
4. Auger Jackshaft (Zerk in Sprocket Hole)
5. 2 Idler Arms (1 Zerk on each)
6. Gearbox Bearings (4 Remote Zerks)
7. Over-Running Clutch (2 Places)
8. Front Expeller Bearing (1 Remote Zerk)
LUBRICATION
GREASING
There are numerous grease fittings on the
Top Shot
. Lubricated properly and often with a high-quality
grease, will prolong the life of the spreader. Replace any missing or plugged grease fittings.
Wipe dirt from the fittings before greasing to prevent the dirt from being forced into the bearing or pivot.
Grease should come out around the shaft on sleeve type bearings. To minimize dirt build-up, avoid
excessive greasing. After greasing, wipe off the excess grease from around the outside of the bearings
to prevent the accumulation of chaff and grit.
NOTE:
Grease all fittings at the intervals of operation listed, before and after storing the Top Shot. Use
a good grade of Lithium-base grease.
-30-
1.
4.
7.
2.
5.
6.
3.
8.
Содержание 5134
