H&S 2957, Руководство оператора

Страница: 39 / 50

5.5.5 Shear Bolt:
Each PTO driveline is equipped with a shear bolt on the implement end of the driveline. It is
used to protect the Processor from jamming, plugging or overloading. Replace the shear bolt as
needed. Be sure to use the appropriate shear bolt when replacing. Using the wrong shear bolt
can result in damage to the machine.
Refer to Machine Specifications for proper shear bolt sizing (Section 7).
5.5.6 Hitch:
The Bale Processor is equipped with an adjustable clevis style hitch. It is a two piece design
and is to be installed as shown. Do not use the hitch with the clevis on top as it does not have
sufficient strength to support the vertical loads imposed by the Processor. Do not remove the
clevis section unless the tractor drawbar is equipped with a clevis. The clevis is required to
counter the uplifting forces that can be encountered under some circumstances. Adjust the
height of the hitch so that the Processor is level when connected to the tractor.
On tractors equipped with a clevis style drawbar, the clevis on the Processor must be removed
to prevent binding when turning or on uneven terrain.
Check hitch and clevis bolts on a weekly basis to make sure they are properly tightened.
-
5.9
-