- 26 -
Taking out ice cream,
Extrude out
69 seconds Speed=L
It displays the parameters during the setting program.
It displays the error message when the machine detects an error.
5.6.2 Increase and Decrease Key
,
Under STANDBY MODE, push both
and
keys at same time will
enter parameters setting mode. (Details about the parameters setting please refer
Chapter 5.7)
Under ice cream making mode, push key
or
will increase or
decrease the hardness volume, the controller will record the new volume
automatically.
Under parameters programming mode, push key
or
will increase
or decrease the parameter volume.
5.6.3 Reset/ Save and exit
Under parameter setting mode, push
will save the parameters volume and
exit.
5.6.4 Rinse key
Push
under READY MODE, the motor will agitate at high speed and it will
stop automatically after the rinse-timer goes out.
Rinsing....
81 seconds
Push
or
will stop rinsing and exit to READY MODE.
_________________________________________________________________
CAUTION
Put some (warm and cleaning) water into the cylinder before you run the
RINSE, otherwise may cause the FREEZING CYLINDER worn abnormally.
_________________________________________________________________
TM