H&L Igloo Verandah Installation Manual
Dear Customer!
We congratulate you on your purchase of the H&L Igloo Verandah. We wish you that it will
contribute to your satisfaction with healthy calf rearing.
The following installation instructions are meant to make installing the H&L Igloo Verandah
easier for you. Please note also the installation manual for the H&L Igloo, in particular the
safety messages contained in it. Some of the details shown by the photographs in this manual
may not correspond to the H&L Igloo Verandah as it is currently shipped. The reason is that
your H&L Igloo Verandah is supplied in the most up-to-date version, including all technical
improvements.
The installation will require 3 persons and the following tools:
-
Driller with 11mm bit for wood and 6.5 / 8.5 / 10.5mm bits for metal
-
Tape measure
-
Grease gun
-
Wireless driller-screwdriver with 8 / 10 / 11mm nuts
-
Step ladder (2 units)
-
Chalk line
-
2 to 3 screw-clamps
-
Spanners :
2 size 10, 2 size 13, 2 size 17, 2 size 22
-
Multi-grip pliers
-
Bow saw/backsaw
-
Hammer
Installation Instructions
Please refer to the component overview drawing!
Start by mounting the basic frame.
1.
For the installation of the H&L Igloo
Verandah, select a place that is as level as
possible.
Position the lateral (IV1110) and the
front/rear segments (IV1210) at this
location according to a 5 x 5 metres set-up.
Note:
•
taller side of the lateral segments toward the
igloo
•
fastening brackets of the rear gates
(IV1310) pointing toward the igloo
