Handicare PUMA KINETIC, Руководство по обслуживанию

Страница: 30 / 99

Maintenance
30 Version 2011v1
3.3.2 Replacing the tire of the drive wheel
When replacing a tire of a drive wheel neutral should not be switched off, so that the wheel does not turn along.
The tire should be replaced as follows:
•
Support the wheelchair so that the wheel is elevated.
•
Let the tire run empty completely by pulling out the valve.
•
Using tire levers, pull the front of the tire across the edge of the rim.
•
Carefully pull the inner tube across the edge of the rim.
•
Push the valve from the opening in the rim.
•
Pull the inner tube from the tire.
•
The whole tire can now be removed.
Now the tires (with repaired or new inner tube) should be assembled as follows:
•
Place one side of the tire around the rim.
•
Put the valve of the inner tube through the opening in the rim and press the inner tube into the tire.
•
Place the tire around the rim.
•
Use tire levers to place the tire around the rim: be careful not to damage the inner tube with the tire
levers.
The inner tube must not become jammed between the rim and the tire.
•
Pump up the inner tube, see 'technical data'.
•
Remove the support from the wheelchair.
The wheelchair is ready to drive again.
EBAPUM-010702020-nl.doc
3.3.3 Replacing the drive wheel
•
See fig. 020702040.
When the rim of a drive wheel is replaced, the neutral should not
be switched off, so that the wheel does not turn along.
Replace this as follows:
•
Support the wheelchair so that the wheel is elevated.
•
Remove the cap (A) with a screwdriver.
•
Bend back the lip on the locking plate (B).
•
Using a box spanner with a key width of 17 mm,
remove bolt (C) with the washers that holds the rim
onto the drive unit.
•
Pull the wheel (E) off the shaft.
•
When the wheel is removed, a key (F)
may come loose or remain in the rim.
This key must be slid into the key way
of the outgoing shaft of the drive unit.
•
If there is no key, this will cause drive
problems.
•
Behind the key, a bush is slid onto the
outgoing shaft. This bush does not have to be removed.
Now the new wheel can be assembled as follows:
•
Put a layer of grease on the outgoing shaft (G) of the drive unit.
•
Slide the wheel onto the outgoing shaft of the drive unit.
Attention:
•
Make sure that the notch in the rim falls over the key.
•
The locking plate has to be replaced: do not use the old one again.
•
Screw the bolt with the rings and the locking plate in the thread hole of the outgoing shaft of the drive
unit and tighten the bolt with the box spanner.
•
Bend back the lip on the locking plate, so that the bolt is prevented from being unscrewed.
•
Remove the support from the wheelchair.
The wheelchair is ready to drive again.
F D
G E B C A
020702040