handi quilter Fusion QM32469, Руководство пользователя

Страница: 13 / 46

02/10/2015 www.HandiQuilter.com HQ Fusion User Manual | 13
Installing the Thread Mast
To install the thread mast
1. Locate the threaded hole on top of the machine
near the rear by the hand wheel.
2. The thread mast comes with the washer and
nut on it. Remove the nut and washer, replace
the nut onto the mast and then place the
washer under the nut and onto the machine
painted surface. The washer protects the
painted surface when the nut is tightened.
3. Tighten the mast clockwise until it is securely in
place. Use the nut to secure the mast to
the machine.
NOTE : The eyelets of the thread mast must be centered over the spool pins so the cone will not
pull, turn, or tilt causing thread tension problems.
Installing the Laser Stylus
To attach the laser stylus to the top of the machine
1. Locate the laser stylus guide post, the laser holder. and the laser stylus.
2. Locate the threaded hole on top of the machine near the front
(see diagram B, #27). The laser stylus guide post comes with
the washer and nut on it. Remove the nut and washer, replace
the nut onto the post and then place the washer under the nut
and onto the machine painted surface. The washer protects the
painted surface when the nut is tightened.
3. Tighten the post clockwise until it is securely in place. Use the
nut to secure the post to the machine. Be sure the laser stylus is
inserted into the laser clamp.
4.
Slide the laser clamp over the post to the desired height.
5.
Plug the laser into the top port on the side of the front electronic control pod (see diagram C, #232).