CPS-Q5 User Manual
20
1.
Help status
1.
The SOS default setting is On. If you want to turn it Off, scroll using
button,
select OFF, and press
.
NOTE:
the SOS status (ON or OFF) is ONLY for the SOS button on the handset only.
2.
SOS Numbers
1.
Press
, highlight the first empty slot and press
, enter the first
SOS number you would like to call, then press
.
2.
Scroll down to the next empty slot and press
, enter the second SOS
number, the press
. Repeat these steps for the remaining empty slots.
Activating the SOS Alarm
1.
When the SOS numbers have been entered into the phone and you have an
emergency, press the SOS button on the handset or the communicator. This triggers
the SOS alarm and begins dialing the numbers you have entered.
2.
If the first number is busy, the CPS-Q5 system will detect a busy signal, within 8-10
seconds it will dial the next number (unless there is only one number registered in
the SOS list, the same number will be dialed again).
3.
A maximum of 5 attempts for each number listed in the SOS call list.
4.
When the call party receives the SOS call, they will hear the following
announcement: “Hello, this is an emergency call, please press 5 to confirm” If the
call party doesn’t confirm the SOS call by pressing 5, the phone will automatically be
disconnected after 45 seconds and dial the next number (unless there is only 1
number registered and then the unit will call the same number again).
5.
When the party receiving the SOS call presses 5, the call will be in SPEAKER mode.
When the SOS call has ended, the unit will automatically disconnect.
Note:
during SOS call, the keypad will be lock! To unlock the keypad or to cancel a false SOS
call, please press and hold the SOS button on the handset for 7 seconds or place the phone
on the base. On the side of the Communicator press and hold the On/Off button until a
series of tones are heard.
Speed Dialing
Speed dialing is option to dial up to 8 numbers with a single press and hold (3 seconds) of
one pre-designated key from 2 to 9.
