15
2022_001
●
Do not overload the product. Use the pressure gauge to
do a check of the applied load. Do not apply pressure
that cause damage to a workpiece.
●
Do not move the product when it holds a load.
●
Do not change the pressure relief valve on the product.
●
Follow the instructions on the warning labels.
●
The operator is responsible for accidents that occur to
other persons and their property.
●
Make sure that you clearly read signs and decals.
Replace signs and decals that have become illegible or
lost.
●
Make sure to always have a god foothold when you use
the product.
●
Keep your hands, feet and other parts of your body away
from the pressing area.
●
Do a check of the product before each use. Make sure
that all screws are tight. Do not use a damage product.
●
Only use the product indoors in dry environment.
2.3 Personal protective equipment
●
Always wear non-slip shoes
●
Wear approved safety glasses or a visor.
●
Wear gloves when you do maintenance. The cutting
blade is sharp.
3
Assembly
3.1 To install the product
1
Install 1 foot (2) and 1 side piece (1) on each side of
the bottom bracket (3). Use the screws M12x35 (4),
washers 12 (5), spring washers 12 (6) and nuts M12
(7). (Figure 1)
2
Install the crossbars (11) on the 2 sides. Use the
screws M10x 25 (13), screws M10 x 30 (12), nuts M10
(8), washers 10 (10), and spring washers 10 (9).
(Figure 2)
3
Install the support plate (15) to the top crossbar (16).
Use the screw M8 x 25 (14). (Figure 3)
4
Install the top crossbar (16) to the sidepiece (1) on the
2 sides. Use screws M16 x 35 (20), nut M16 (19), spring
washer M16 (18) and washer 16 (17). (Figure 4)
5
Install the cylinder (21) in the hole in the support
plate (15). Install the bottom ring nut (22) to the
cylinder (21).(Figure 5)
6
Put the 2 press bed frames (23) together with the 4
M12x130 screws (24) through the bushings (25). Lock
with the nuts M10 (8), spring washers 10 (9) and
washers 10 (10). (Figure 6)
7
Install the press bed frame pins (26) in the press and
put on the installed support frame. (Figure 7)
8
Fit the pump (28) to the right hand crossbar. Use the
screws M10x30 (27), spring washers 10 (9) and
washers 10 (10). (Figure 8)
9
Install the handle (29) and the handhold (30).
(Figure 9)
10
Install the nylon ring (31) and the pressure gauge (32).
(Figure 10)
11
Install the hose. (Figure 11)
12
Install the supporting beams (33). (Figure 12)
4
Operation
4.1 To do before first use
1
Open the release valve and pump until the hydraulic
system is free from air.
2
Do a check of the product. Make sure that all screws
are tight. Do not use a damage product.
4.2 To operate the product
Warning!
Read and understand the instructions
before you use the product.
1
Put a block on the supporting beams.
2
Put the workpiece on the block.
3
Turn the release valve to close it.
4
Pump until the piston is near the workpiece.
5
Carefully align the workpiece.
