HAMPTON BAY Waterton II, Руководство пользователя

Страница: 12 / 16

Glass
holder
Thumb
screws
Bulbs
Glass shade
N O T E : B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
1.Remove the thumb screws from the bottom
of the glass shade. Insert the
bulbs (included) into the light kit
sockets. Max. 60 watts. (Fig. 16)
2.Install the glass shades onto the glass
holder with two thumb screws previously
removed. Be sure to tighten all screws.
(Fig. 16)
3.Remove the three screws from the
mounting plate. (Fig. 17)
4.
(Fig. 17)
5.Carefully push all wires back into the light
kit assembly, then install the light kit
assembly onto the mounting plate with 3
screws previously removed. Be sure to
tighten all screws. (Fig. 17)
6. Restore power and your light kit is ready
for operation.
intermediate
base
While holding the light kit assembly under
y o u r f a n , s n a p t o g e t h e r t h e w i r e
connection plugs.
Figure 16
Figure 17
NOTE: Light bulbs have no warranty,
can be purchased at local light bulb
specialty store or from our service
center.
9. Installing the Light Kit