HAMPTON BAY Waterton II, Руководство пользователя

Страница: 10 / 16

7.
Rubber
washer
Blade
arm
Figure 12
Blade
Screws
Attaching the Fan
Blades
Step 1 Attach blades to blade arms using
three screws and rubber washers as shown
in Figure 12. Start a screw into the arm, do
not tighten. Repeat for the 2 remaining
screws and washers.
Step 2 Tighten each screw securely starting
with the center screw. Make sure the blade
is straight.
Step 3 Fasten the blade arms to the motor
by inserting the tab from the blade arms to
the slot in the bottom motor housing, then
tighten the two screws and washers already
installed in the blade arms (Figure 13).
Step 4 Install an optional light kit if you
wish. Follow the instructions included with
the kit.
Figure 13
Motor
Blade arm
Slot
Tab
All blades are grouped by weight.
Because natural woods very in density,
the fan may wobble even though the
blades are weighed equally.
The following procedure should correct
most fan wobbling problems. Check after
each step.
1. Check that all blade and blade bracket
screws are secure.
2. Most fan wobbling problems are
caused when blade levels are unequal.
Check this level by selecting a point on
the ceiling above the tip of one of the
blades. Measure this distance as shown
in Figure 14. Rotate the fan until the
n e x t b l a d e i s p o s i t i o n e d f o r
measurement. Repeat for each blade.
The distance
should be equal
within 1/8".
deviation
3. Use the enclosed Blade Balancing Kit
if the blade wobble is still noticeable.
4. If the blade wobble is still noticeable,
interchanging two adjacent (side by side)
blades can redistribute the weight and
possibly result in smoother operation.