Hanging the Fan
REMEMBER
to turn off the power. Follow the
steps below to hang your fan properly:
Step 1
. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 5)
Step 2
. Remove the hanger bracket from the
canopy by loosening the two screws on the bottom
of the hanging bracket a half turn from the screw
head and turning the canopy counter clockwise.
(Fig. 5)
Step 3
. Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 4
. Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as shown
in Fig. 6.
Step 5
. Remove the hanger pin, locking pin and
set screws from the top of the motor assembly.
Step 6
. Route wires exiting from the top of the fan
motor through the collar cover, canopy cover,
canopy and then through the ball / downrod. (Fig.
7)
Step 7
. Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig.7). Carefully insert the hanger
pin through the holes in the collar and downrod.
Be careful not to jam the pin against the wiring
inside the downrod. Insert the locking pin through
the hole near the end of the hanger pin until it
snaps into its locked position, as noted in the
circle inset of Fig. 7.
Step 8
. Tighten two set screws on top of the fan
motor firmly (Figure 7)
Step 9
. Place the downrod ball into the hanger
bracket socket.
WARNING
FAILURE TO PROPERLY INSTALL LOCKING
PIN AS NOTED IN STEP 7 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
4.
CAUTION
REMOVE 5 RUBBER PACKING MOUNTS AND
DISCARD BEFORE INSTALLATION.
Mounting screws
(supplied with
electrical box)
Hook
Ceiling mounting
plate
UL Listed
electrical
box
120V Wires
Washers
Figure 6
Pin in locked position
Motor collar
Motor wires
Ball/downrod
assembly
Ceiling canopy
Tighten screws
firmly
Figure 7
Hanger pin
Locking pin
Collar cover
Canopy cover
Figure 5
Ceiling
mounting
plate
Ceiling
canopy
Canopy
cover
