9
Operation
Fireplace Operation
Push the Power button to supply power to all
functions of the fireplace.
The Heater button on the remote control only turns
ON and OFF the heater function.
Press the Flame button to increase and decrease the
flame intensity. There are 6 brightness levels you can
cycle through as well as the OFF setting.
Press the Timer button to cycle through the 10 timer
settings (30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H,
7H, 8H and 9H) and the OFF setting.
1
3
2
4
Powering the fireplace
Adjusting the heater
Adjusting the flame
Setting the timer
NOTE:
To change between °F and °C press and hold the
Heater button on the control panel for 10 seconds.
NOTE:
The control panel can be accessed at the upper-right corner of the insert. When a function is changed
from the control panel or remote control there will be a corresponding indicator (see Figure 1) on the upper-right
of the projection screen. The indicator shows the function changed and the level selected by the control panel or
remote control. When the function is turned off, the corresponding indicator will flash several times and then fade
off.
NOTE:
Holding the Power button on the control panel for
10 seconds will disable the heater function.
NOTE:
All previous settings are held in memory, so the
next time you power up the fireplace, the unit will turn on
with the same settings.
°
°
C
F
Fig . 1
Setting 6-2 decrease in brightness.
Setting 1 has no blue glow and is full brightness.
To turn off the timer press the Timer button. The
indicator will then display the current setting. Press
the Timer button again and the display will flash 00
indicating the timer is turned off.
To set the thermostat use the Heater button on the
control panel. The thermostat setting range is 62°F -
82°F or 17°C -27°C or always ON.
Push the Power button again to turn off all functions.
When the timer runs out all functions are turned OFF
and the fireplace is put into standy mode.
