Hampton
®
H27 Direct Vent Freestanding Gas Stove
43
MAINTENANCE
11)
Carefully lift the burner tray assembly out.
REMOVING VALVE
If your valve requires maintenance or replace-
ment, use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1)
If optional fan is installed, disconnect power
source to stove.
2)
Remove access panel.
3)
Disconnect gas line to stove.
4)
Disconnect 3/8" NPT pipe from 90
o
elbow
on valve or fl ex connector.
5)
Disconnect the two (2) switch wires from
valve.
6)
Disconnect piezo wire.
7)
Lift off the Cast Top and remove the Cast
Front and glass door (refer to pg. 41).
8
) Carefully remove the logs and embers.
9)
Remove burner by removing the 2 screws
on each side and then lifting the burner tray
out.
Note: Use a magnetic type screwdriver if
possible.
12)
To remove the valve, remove the 4 screws (2
per bracket) that hold the valve to the valve
bracket assembly.
13)
To replace the burner tray assembly, simply
reverse these instructions.
To remove valve from valve assembly, con-
tinue.
14)
Remove two (2) thermopile wires.
15)
Remove thermocouple with a 9 mm (metric)
wrench.
16)
Remove pilot nut with an 11 mm wrench.
17)
Remove valve to orifi ce nut with a 13/16"
wrench.
18)
Remove inlet pipe with pipe wrench. Note
orientation of 90
o
elbow.
19)
Remove two (2) phillips head M5 screws on
each side of the valve.
20)
Remove valve and remove gas out 90
o
brass
fi tting. Note orientation of fi tting.
INSTALLING
VALVE ASSEMBLY
1)
To install a new valve assembly, reverse in-
structions for
removing valve
. See assembly
steps 1-12.
2)
Check for leaks and manifold pressure. See
Gas Pressure Test
instructions.
3)
To reinstall valve, reverse instructions for
removing valve assembly, steps 13-19.
3)
Unclip the black and white wires from the
fan motor.
4)
Remove the 2 bolts holding the fan to the
rear base. Disconnect the green ground
wire from the right side of the fan as soon
as you can reach it.
Screws
10)
Remove all 6 screws holding the burner tray
assembly in place.
Lift Rear Panel off the 2 top bolts
bolts
screws
screws
2)
Remove the rear access panel on the back
of the stove by removing the 2 screws under
the rear panel, then lift off the 2 screws at
the top. Take care not to cut wires when
lowering the panel.
Replacing the Fan:
Reverse the above steps (1 - 4). Make sure the
fan wires and the ground wire are reattached.
