Hanging the Fan
REMEMBER
to turn off the power. Follow the
steps below to hang your fan properly.
Step 1
. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 4)
Step 2
. Remove the hanger bracket from the
canopy by loosening the two screws on the bottom
of the hanging bracket a half turn from the screw
head and turning the canopy counter clockwise.
(Fig. 4)
Step 3
. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly. (Fig. 5)
Step 4.
Route wires exiting from the top of the fan
motor through the collar cover, canopy cover,
canopy and then through the ball/downrod. (Fig. 5)
Step 5.
Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig.5). Carefully insert the hanger
pin through the holes in the collar and downrod.
CHANGING THE DOWNROD
(OPTIONAL)
NOTE:
Your fan comes with a 4" downrod
attached to the hanger ball. In addition you have
been provided with a 6" downrod to use if desired.
If you choose to use the 6" downrod, perform the
following steps:
1. Remove the hanger ball from the downrod by
loosening the set screw at the top of the downrod
which holds the hanger ball to the downrod.
2. Slide the hanger ball down the downrod and
remove the support pin.
3. Insert the support pin in the holes at the top of
the 6" downrod and slide the hanger ball up the 6"
downrod. Make sure the support pin is properly
seated in the grooves in the top of the hanger ball.
4. Tighten the set screws firmly.
Step 6
. Tighten two set screws on top of the fan
motor firmly (Figure 5)
Step 7
. Install the hanger bracket to the outlet
box; be sure to align the holes in the hanger
bracket with the post holes in the outlet box and
secure with screws and washers provided by the
outlet box.(Figure 6)
Step 8
. Hanging the assembled fan onto the
mounting bracket, place the downrod ball into the
mounting bracket. Rotate fan until the slot of the
downrod ball locks into the tab of the mounting
bracket. (Figure 7)
Step 9
. Secure the safety cable to the building
structure as shown in Fig. 7
Step 10
. Connecting the wires (see making the
electrical connections)
WARNING
FAILURE TO PROPERLY INSTALL LOCKING
PIN AS NOTED IN STEP 5 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
4.
Be careful not to jam the pin against the wiring
inside the downrod. Insert the locking pin through
the hole near the end of the hanger pin until it
snaps into its locked position, as noted in the
circle inset of Fig. 5.
CAUTION
REMOVE THE 5 SCREWS FROM THE
MOTOR SUPPORT PLATE, DISCARD THE 5
SCREWS AND MOTOR SUPPORT PLATE.
