10
Assembly - Attaching the Fan Blades
Attaching the blades to the blade
brackets
Fastening the blade assemblies to
the motor
1
2
□
Attach a blade (F) to a blade bracket (G) by inserting screws
(AA) into the holes in the blade and through the blade
bracket. Note that the rubber washers are preattached to
the blade bracket.
□
Tighten each screw securely.
□
Repeat these steps for each blade (F) and blade bracket (G).
□
Fasten a blade assembly to the fan-motor assembly (D) by
inserting the alignment post into the slot on the bottom of
the fan-motor assembly and tightening the blade bracket (G)
screws. The blade bracket screws are pre-installed into the
blade bracket (G).
□
Repeat this step for the remaining blade assemblies.
AA
F
G
D
G
Standard Mounting
Close-to-Ceiling Mounting
□
Align the locking slots of the ceiling canopy (C) with the two
screws (SS) in the slide-on mounting bracket (A). Push up to
engage the slots and turn clockwise to lock the canopy (C) in
place.
□
Firmly tighten the two mounting screws (SS).
□
Install the remaining two mounting screws (SS) into the holes
in the canopy (C) and tighten firmly.
□
Carefully unhook the fan from the slide-on mounting bracket
(A) and align the locking slots of the ceiling canopy (C) with
the two screws (SS) in the slide-on mounting bracket (A).
Push up to engage the slots and turn closewise to lock the
canopy (C) in place.
□
Immediately tighten the two mounting screws (SS) firmly.
□
Install the remaining two mounting screws (SS) into the holes
in the canopy (C) and tighten firmly.
6
WARNING:
When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
D
C
A
SS
WARNING:
The locking slots of celling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
D
C
A
SS
Assembly - Hanging the Fan (continued)
