7
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparation for standard mounting
□
Loosen, but do not remove, the setscrews (HH) on the collar
on top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (D).
□
Carefully inset the hanger pin (CC) through the holes in the
collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (HH) on the collar on top of the
fan-motor assembly (D).
□
Remove the slide-on mounting bracket (A) from the canopy
(C) by loosening the four screws (SS) on the the top of the
canopy (C).
□
Remove the two non-slotted screws (SS) and loosen the
slotted screws (SS). This will enable you to remove the
slide-on mounting bracket (A).
□
Make sure the slot openings are on top and route the
wires existing at the top of the fan-motor assembly (D)
through the canopy (C) and then through the ball/down-
rod assembly (B).
2
3
1
C
A
SS
C
B
D
C
B
D
CC
DD
HH
WARNING:
Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
