4
Pre-Installation
WIRING DIAGRAMS
BLACK (LIVE)
WHITE (NEUTRAL)
GREEN (GROUND)
FA N
QUICK CONNECTOR INSTRUCTIONS
To be sold only with installation instructions.
WARNING:
Wiring must comply with all applicable electrical
codes. Turn OFF power before removing or installing connectors.
WARNING:
COPPER TO COPPER ONLY. Do not use Aluminum
wire.
CAUTION:
Accessory part (quick connector) should meet
installation instructions below.
NOTICE:
The connector is reusable on solid wires of the same wire gage
or smaller. Do not reuse the connector on stranded wires.
NOTICE:
Important wire information. Maximum temperature rating 105˚C
(221˚F). 600 volts maximum for building wire and 1000 volts maximum
in signs and lighting fixtures. The acceptable wire range includes: Solid:
12-18 AWG.
□
Strip wires 3/8 in. - 1/2 in.
□
Grip the wire firmly and push the stripped end of the wire
into the open port of the connector. Use only one conductor
per port.
□
Verify the stripped end of the wires is fully inserted to the
back of the connector.
Quick
connect
Product
wires
House
wires
PLANNING INSTALLATION
Before beginning installation of the product, make sure all parts are present. Compare parts with the package contents list and hardware
contents. If any part is missing or damaged, do not attempt to install the product.
WARNING:
Turn off electricity at breaker box before beginning
installation.
NOTE:
Installation may vary depending on how the previous
bath fan was installed. Supplies necessary for the installation of
your bath fan are not all included. However, most are available at
your local home improvement or hardware store.
1. Carefully remove the unit from the carton.
2. Check the area above the installation location to be sure
that wiring can run to the planned location, that duct work
can be run, and the area is sufficient for proper ventilation.
3. Inspect duct work and wiring before proceeding with
installation.
4. Before installation, provide inspection and future
maintenance access at a location that will not interfere
with installation work.
5. You may need the help of a second person to install this
fan; one person on the attic side and one on the room side.
