Connectors
Screws
Pull chain
Glass
shade
Bulbs
Light kit
assembly
Glass cap
Metal nut
Finial
Mounting plate
Figure 17
9. Installing the Light
Kit
While holding the light kit assembly
under your fan, snap together the wire
connection plugs .
N O T E
: B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
1.
2. Carefully push all wires back into the
switch housing, then install the light kit
assembly onto the mounting plate with 3
screws provided. Be sure to tighten all
screws. (Fig.17)
3. Install 2 x
13 Watt compact fluorescent
bulbs (included).
4. Remove the metal nut, glass cap and finial
from the light kit. Raise the glass shade
up against the light kit. Place the metal
nut with rubber on the top over the stem
and turn it clockwise until it locks up
a g a i n s t t h e g l a s s s h a d e . D o n o t
overtighten. (Fig. 17)
5. Raise the glass cap and final against the
glass shade and secure it to the stem by
turning the final clockwise until snug. Do
not overtighten. (Fig. 17)
Note:
Make sure to leave enough space
between the fan pull chain and the bulbs so
the chain doesn't rub against any of the bulbs.
8. Installing the Mounting
Plate
Step 1.
Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2.
Place the key holes on the mounting
plate over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 16)
Figure 16
Mounting plate
Mounting ring
Screws
