5
Assembly
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
2
Attach the tabletop
3
Tighten the nuts to the bolts
□
Use the hex bolt driver (HH) and hex wrench (GG) to tighten
all nuts (BB) and bolts (AA). (Note: each bolt and nut must
be tightened a few revolutions at a time.)
□
Repeat until all bolts (AA) are tight. (Do not over tighten.)
□
Cover nuts and bolts with covers (DD and EE) provided.
□
It is recommended that you turn the table by grasping the
tabletop (A) surface, but not the legs (C). Note: If you use an
umbrella, please add an umbrella hole protective ring to the
umbrella hole on the top table.
1
Attach the table legs
□
Attach a leg (C) to the leg connector bracket (B) by carefully
guiding the bolts (AA) already in place on the table legs (C)
(each leg has two bolts) through the holes in the leg
connector bracket (B).
□
Add a washer (CC) and nut (BB) to the end of each bolt (AA)
as shown in the diagram.
□
Hand tighten only.
□
Repeat for the other three legs.
□
Place the tabletop (A) up-side down on a flat, solid surface.
□
Attach a table leg (C) to the tabletop (A) by using two bolts
(AA) and washers (FF) as shown in the diagram.
□
Guide the bolts (AA) through the holes in table leg (C), into
the pre-drilled holes in the tabletop (A).
□
Hand tighten only.
□
Repeat for the other three legs.
KK (Preassembled)
B
C
DD
BB
CC
A
C
FF
AA
EE
