12
Assembly - Attaching the Light Kit
Attaching the light kit
Installing the bulbs and attaching
the glass bowl
12
13
□
Remove the three screws (VV) from the light kit fitter
assembly (E) and save them.
□
Align the three holes in the switch cup below the fan motor
assembly (D) with the three holes in the switch cover of the
light kit fitter assembly until it clears the reversing switch
in the switch cup.
□
Connect the wires from the light kit fitter assembly (E) to
the wires from the fan motor assembly (D) by connecting
the molded adaptor plugs together. Carefully tuck all wires
and splices into the switch cup.
□
Position the light kit fitter assembly (E) and re-install the
three screws that were removed in first step to secure the
light kit fitter assembly properly.
□
Remove the rubber washer, hex nut, bowl cap (SS) and finial
(TT) from the light kit fitter assembly (E).
□
With power off, install the two LED bulbs (K) (Max. 9W,
included) by screwing into the light bulb sockets.
□
Position the glass bowl (I) over the threaded nipple and pass
the pull chain for the fan through the pull chain guide on the
side of the light kit fitter assembly to avoid the chain from
touching the glass bowl.
□
Re-install the rubber washer, hex nut, bowl cap (SS) and
finial (TT) to the threaded nipple to secure the glass bowl (I)
properly.
□
Attach the pull chain extension (EE) to the light pull chain and
the fan pull chain.
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
CAUTION:
Do not over tighten the hex nut. Overtightening the
hex nut may cause the glass to break.
NOTE:
Notice the location of the fan’s slide switch. This is the
switch used to change the fan’s directional rotation. For more
information on the operation of this switch, see Operating
Your Fan on page 13.
E
VV
E
E
J
SS
TT
EE
I
EE
