HAMOKI TP-22L, Инструкция по эксплуатации, Страница: 8 / 13

6.
Clean the outside of the cabinet with a damp cloth and detergent. Abrasive cleaning
products such as wire wool and scouring pads will scratch the finish.
7.
The pressure fryer is designed to be splash proof. On no account should you use a
water jet or a steam jet on the cabinet. If it is suspected that the control circuit has
been affected by water, switch off at the control circuit has been affected by water,
switch off at the mains, and remove the 13amp plug from its socket, and leave the
fryer in a warm place to dry out. Do not wash in water before cleaning.
8.
Before re-energizing after damp, a qualified electrician is required to check the
electrical insulation degree of the pressure fryer, and then reopen after confirming
correctness, otherwise it will be dangerous to use.
OPERATING INSTRUCTIONS
When using this pressure fryer for the first time, smoke and abnormal odour may
appear at the beginning of heating, and this will gradually disappear after being heated
for a while. This state is normal. If smoke appears after using for a while, do not
continue to use the unit and investigate the cause of the smoke.
1.
Power On/Off Key: Plug in the fryer and power on the unit. The power on indicator
will flash to show it is on and working. Pressing power button repeatedly will power
down the unit.
2.
Valve Safety Latch: If the indicator light is off, check if the oil drain handle is closed.
The handle should be placed completely in the leftmost position, the valve safety
latch will be automatically placed in the closed position and test the power supply
again. If the oil drain handle is not closed properly, the power may not turn on.
3.
Solenoid Valve Filter: In order to prevent the solenoid valve from being blocked by
debris, a filter is installed at the front end. The filter should be cleaned after a period
of use. Use a spanner wrench to unscrew the hexagon bolt on the filter, remove the
metal filter inside to clean it, remove debris, and then put it back.
Open by turning hexagonal bolt
Remove perforated filter to clean