SAFETY WARNING
In order to ensure the user's safety, environmental sanitation and property assurance,
please be sure to observe and clarify the following precautions:
1.
Please read the instruction manual carefully before use, and keep it safe in case of
operator change, future maintenance or other reference.
2.
Fully understand and familiarize yourself with the symbols, graphics and warning signs
marked on the fryer before use and strictly abide by them.
3.
Keep in mind the manual warnings, cautions and other signs attached to the pressure
fryer.
ANNOTATION:
∆
WARNING
– Ignoring this mark and misusing, can result in personal injury or fire risk.
∆
CAUTION
– Ignoring this mark and misusing, will cause personal injury.
∆
ATTENTION
– Disregarding this mark, mis-operation will cause the fryer to malfunction
and affect the performance.
WARNING:
1.
Be sure to use a power cord, power switch and outlet that are higher than the unit’s
power. (rated current 16A or more).
2.
Do not touch the power cord or pull the plug with wet hands, to avoid risk of an electric
shock.
3.
Do not place the power cord in a hard-pressed or high-temperature facility, especially
in a metal-extrusion area, with sharp edges where it is easy
to break the power cord.
Do not lay the power cord on the channel.
4.
Appropriate food is suggested to be added to the pot one at a time. Risk of fire may
occur if food is added in excessive of maximum level, causing an oil spill.
5.
Please replace the power cord immediately once finding it damaged or scratched,
otherwise it may cause an electric shock or fire risk.
CAUTION:
1.
A strong exhaust suction device should be installed above the exhaust port of the
electric pressure fryer. The exhaust gas should be exhausted to the outside with a
metal ventilation hose.
2.
Replace the power cord with the same type of YCW or YZW flexible oil-resistant soft
cable, and the wire diameter should meet the requirements of power consumption.
3.
Install an all-pole disconnected power switch, power fuse or fuse suitable for the power
unit near the device. The grounding wire terminal must be connected to the ground