5
XB2 Kit Installation
Installing the components
Where the socket for the expression pedal was located, the USB
socket is installed in the rear panel. For this, drill two 3mm holes
at a distance of 29mm close to the existing drill holes, but offset
upwards by about 1mm.
Install the interface board 1. If you want to use
the optional HX3.5 Extension Board, plug the
connector with the long 14 core cable ribbon
into PL16 beforehand. Connect the connector
of the 11pin Leslie socket to PL17 and the
three connectors from the pots at the front to
PL12, PL14 and PL18.
Plug the USB cable into the socket on the
HX3.5 board. Place the board close to the
metal brace that supports the lid. Place the four
5mm spacers underneath and screw the board
to the floor with Spax screws.
If you use the optional extension board, screw
it right next to the HX3.5 mainboard. Connect it
with the short 26 connect the 6 core flat cable
and the 14 connect the 6 core flat cable
leading to the interface board 1.
