Hammer HNC3 825, Перевод оригинальной инструкции по эксплуатации

Страница: 57 / 80

57
HNC3 825 / HNC3 825 perform Use
Tip: Bridging for nesting applications
When nesting is being carried out, it is recommended to leave
material bridges between smaller components. As otherwise the
final edge of the loose workpiece will be routed and this can lead
to dimensional deviations.
9.3 Switch off the machine
Stop the machine in an emergency
Push the [Emergency stop] .
🡆
Machine movements will stop.
🡆
Machine is in emergency state.
Switch off the machine
Switch off the machine and if applicable the frequency converter.
9.4 Processing information
9.4.1 Compensate for any bend in the workpiece
If the workpiece is bowed, then clamp it with the bow facing upwards. If locking
holes are drilled for groove nuts, then they have to be chosen in such a way, that
the bow will be optimally compensated against.
Fig. 41: Workpiece bow
9.4.2 Influence of the tool on working accuracy
The length, number of edges, cutting angle and diameter of the tool influence the
working accuracy that is achievable. The tools differ greatly from manufacturer to
manufacturer.
●
Use sharp tools.
●
Select the feed rate appropriate to the application.
● Observe mechanical load limits of the tool.