MTS SHOULDER PRESS Assembly Instructions
10
Assembly Figure 6. Connect the belts to the weight stack.
7.
Run the belts through the arm pulleys and bolt down the belts.
Thread the belts from the weight
stacks through the arm pulleys to the belt plate. With the weight stack pin in the bottom (150 lb.) plate, pull
the belt until it’s tight. Use the 3/8” x 1-1/4” bolts and plates (circled) and tighten down the belt to 20 ft/lbs.
Cut off the belts leaving about one inch beyond the belt plate.
Use a heavy scissors or utility knife to
cut off the belt.
Assembly Figure 7. Belt routing through arm pulleys. Cut off excess.
NOTE: THE 3/8” STAR WASHERS THAT LOCK DOWN THE BELTS TO THE ARMS
WILL NEED TO BE REPLACED EACH TIME THE BOLTS ARE LOOSENED FOR
BELT MAINTENANCE.
