MTS ROW Assembly Instructions
7
1. Bolt together seat assembly.
The seat assembly is shipped in three pieces as shown below.
Fasten the chest pad and seat cushion to the seat assembly by lining up the bolt holes in the
cushions with the bolt holes in the seat frame. Using a ¾” socket wrench, fasten the chest
pad to the seat frame using four 3/8” x 1-1/2” bolts and 3/8” flat washers. Fasten the seat with
two 3/8” x 2-1/2” bolts and 3/8” flat washers.
Plastic washers (4)
Install chest pad
3/8” x 1-1/2” bolt
w/flat washer (4)
Use 3/4” socket to
loosen bolts to
install chest pad
Use 9/16” socket to
tighten nut and 5/32”
hex key to install sleeve
Install seat cushion
3/8” x 2-1/2” bolt
w/flat washer (2)
3/8” x 1-1/2”
UPHOLSTERY
BOLT
3/8” x 2-1/2”
UPHOLSTERY
BOLT
Assembly Figure 1. Build the seat assembly.
NOTE: AT THIS POINT, YOU MAY WISH TO BOLT THE BASE OF
THE SEAT ASSEMBLY TO THE BOTTOM BRACE OF THE MTS ROW.
USE 2-3/4” BOLTS AS SHOWN IN FIGURE 6 IF YOU WISH TO DO
THIS.
