MTS ROW Assembly Instructions
14
8.
Bolt the right arm to the frame.
Slide the right arm up into the top of the MTS ROW with the
arm facing inward as shown at left. Insert two ½” x 2-3/4” bolts on the outside of the arm
through the bushing and tighten. Insert two ½” x 2-3/4” bolts through the inside bushing and
tighten. All bolts should be inserted through the top piece Nuts and star washers should be on
the bushings as shown in the detail view in the figure.
1/2” x 2-3/4”
(4)
2-3/4” BOLT
Assembly Figure 8. Bolt right arm to frame.
NOTE: THE STEP BELOW MAY HAVE BEEN COMPLETED AT THE
FACTORY.
9.
Connect the belts to the weight stacks.
Connect the belt to the weight stack by looping
the belt over the belt pin as shown below. Bolt down the belt plate to 30 ft/lbs. as shown in
the figure below.
NOTE: THE “RIBS” IN THE BELT SHOULD BE FACING TOWARD
THE BELT PIN AS SHOWN BELOW.
