HAMMELMANN HDP 502 / S 1100-50, Руководство по эксплуатации, Страница: 268 / 311

Maintenance, dismantling, assembly Page 5 of 10 Chapter 7
For local contact details:
www.sterlingfluidsystems.com In the search to improve continuously its products,
Sterling Fluid Systems reserves the right to modify its
products at any time without prior notice.

(Sterling Fluid Systems BV) 2001
Design with quench (AX3, AXS, AXK)
Detach the cover 16.50, O-ring 41.23 and lip
seals 42.11.
16 .50
16.10 41.23
42.11
Design with heating (AY3, AYS, AYK)
Detach the cover 16.50, O-rings 41.22 and
41.23.
16.10 41.22 41.23 16. 50
4. Remove the static part of the mechanical seal
43.30 and pin 56.10.
56.10
43.30
16.10
Bearing design B, C or 2 :
1. Release hexagonal screws 90.11, remove
V-seal 42.20 in case of grease lubrication,
dismantle bearing cover 36.00 and flat gasket
40.02. Remove the lip seal 42.10 if pump is oil
lubricated.
2. Release the thrower 50.70
3. Undo hexagonal screws 90.12, remove
washer 93.01 and dismantle the pump foot
18.30.
4. For oil lubricated pumps, remove the oil dip
stick 91.60 and remove the constant level
oiler (CLO) 63.80 if any.
42.10 91.60 42.10 40.02 42.20 90.11
90.12 93.01 18.30
33.00 42.20 36.00 50.70 94.00
5. Pull out complete shaft 21.00 with both ball
bearings 32.10 and support washers for ball
bearing 50.50 if any.
6. Remove ball bearings 32.10 and support
washers for ball bearing 50.50.
21.00 50.50 32.10 50.50 32.10
•
For executions with bearing housings 55 and
65:
10.20 90.20
40.00
92.00
90.80
92.06
90.30
50.20 56.00
HAMMELMANN Code no.: 04.03226.0769
Type 32-200