HAMMELMANN HDP 502 / S 1100-50, Руководство по эксплуатации, Страница: 101 / 311

ES 2 – Control
Operating instructions
No.: ES2-Bediener (Volvo)
Page 19, Issue: 04.2016

Copyright Hammelmann GmbH
Germany

D-59302 Oelde

Carl-Zeiss-Straße 6 - 8
2.10 Explanation of the terms/functions at the operators menu
1.
2.
3.
4.
5.
6.
7.
7.1
7.2
8.
9.
10.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
24.
25.
26.
Idle speed delay:
The engine stays at working speed after the bypass opens for the length of
time set so that the tool operator can pause without the engine dropping to idle speed.
Multi gun valve yes/no
: Switches the multi gun valve outputs to active or inactive.
Language
: Select the language which will be displayed at the operators menu.
Display contrast
: Adjust the contrast setting.
Display lighting
: Switching the lighting ON/OFF .
Standby time
: If the set time expires without a signal to close the bypass the unit will shut down.
Set min. pressure:
Sets the minimum high pressure value (in bar) that the unit should not run
below. The minimum high pressure value is changing automatically when changing the set value.
The difference will stay.
Delay min bar ON
: Delays switching on the monitoring time of the HP – min.
Delay min bar OFF:
Delays switching off the monitoring time of the HP – min.
Hose length:
Select either 20m or 100m. The regulation will start depending on what is selected
after the set time.
Control mode:
If programmed at the factory, changeable between control of engine speed and
control by pressure setting.
Pressure steps:
Use password to select factory programmed pressure steps.
Protocol
: Displays the history of faults with dates, times and regularity. Shows values and actual
faults of CAN-Bus
Function menu
: Displays the status of the total inputs in the ES 2. Enter menu by pressing the
OK (confirm) keypad.
Pressure to learn:
Start Teach-in-function
Consumer number:
Adjust the number of consumer (1 . . . 5)
Consumer 1:
Consumer 2:
Adjust the flow rate
Consumer 3:
of each consumer
Consumer 4
at multi gun operation.
Consumer 5
:
Set clock:
Set the clock time, that will be displayed in ES2
Set date:
Set the date, that will be displayed in ES2
Lock keypads:
Prevents use of the keypads.
Remote control:
Enables receipt of serial data, for example from a SPS or a PC (remote control)
Modem:
Activation of the far maintenance about modem
Pos: 65 /xxxxxxxxxxxxxxxxxxx @ 0\mod6_2.docx @ 1188 @ @ 1