Hamilton 400 D, Руководство по установке

Страница: 2 / 13

WARNINGS AND DISCLAIMER
Installation Precautions
1) This humidifier will be connected to and used under water pressure and it must be installed in such a way that if a leak
occurs, the water could not cause any damage to the property. Make sure all water connections are properly installed or water
spill could occur.
2) This humidifier is intended for use on forced warm air circulation furnaces, as well as multi-fuel furnaces where temperature
does not exceed 180°F (82ºC). Higher temperatures will damage your humidifier and possibly cause overflow condition and
water damage to your home.
3) Do not install a humidifier where surrounding temperatures may be 32°F (0ºC) or colder. Freezing water will damage the
humidifier and burst the supply pipe, resulting in home damage.
4) Do not install the humidifier or the bypass connection directly on the furnace housing.
5) Do not install the humidifier or the bypass connection on a plenum side where a cooling coil could restrict or inhibit the
airflow through the humidifier.
6) Always check that you are not about to cut or drill into any air conditioning or electrical accessory during installation.
7) Do not install a humidifier on the supply duct where the static pressure exceeds 0.4” Water Column.
8) Do not install a humidifier if the city water pressure exceeds 90 psi. Check the local codes related to pressure reduction.
9) The installation, wiring and plumbing of the humidifier must comply with national and local electrical, plumbing and building
codes.
10) Electrical wiring and water tubing must not come into contact with sharp edges or hot surfaces. For the drainable models,
please make certain the drain tube has no bends, its end placed in a floor drain and there is no resistance to the flow of the
discharged water.
11) The transformer supplied is rated for 120 V power supply. Do not connect it to an installation supplied with another voltage.
12) Do not set the humidity level higher than normally recommended, or condensation damage could occur.
Safety Warnings
1) Please beware of sharp edges when you cut into a metal duct.
2) Always shut the power off before starting the installation. An electric shock from 120 volts could cause serious injury.
1. Required tooling
Tin snips, 3/32” drill, pliers, screwdrivers, electric drill, hammer, centre punch, medium sandpaper.
IMPORTANT NOTE: This humidifier is supplied with RECEX ® screws that allow the use of either a Robertson or Phillips
head screwdriver.
2. Typical installations (Please see Fig. 1)
There are two frequently encountered types of installations: LOWBOY furnace ( 1.1 ) and HI-BOY furnace ( 1.2 ).
3. Principles of operation
•
This humidifier uses a motor driven evaporator pad. Warm air is by-passed from the warm air plenum and forced through
the evaporator pad while it turns in the water pan. Humid air is drawn back into the return duct.
BEFORE YOU START - GENERAL SAFETY AND INSTALLATION PRECAUTIONS
Please read and understand these instructions fully before you begin this installation and save them for future reference.
The manufacturer will assume no responsibility and the warranty will be void if the user does not adhere to the following precautions.
Self-cleaning model:
All instructions pertinent only to the self-cleaning model are shaded in the following text.
The drum contains all the small parts and installation hardware. It is closed by a round metal damper (
10.B
) that
will be used
later
in the installation process. Open the drum to remove all the parts, then re-assemble the drum without the damper.