Hamilton Beach REFHB270BE, Руководство пользователя

Страница: 7 / 33

8. Align lower hinge bracket on opposide side and insert screws into the holes.
9. Align hole in the door with the door pin in lower hinge and gently push down
until firm.
10. Re-install both leveling legs.
11. Align upper hinge bracket with screw holes, insert screws and partially
secure, check that door and cabinet are properly aligned and then secure
tightly.
12. Replace top hinge cover.
NOTE:
As the door gets pressed in during shipping, after reversing the door, the
gasket may have to be reset. This is done to prevent the cool refrigerated
air from escaping. If there is a gap between the door gasket and the
cabinet, set the gasket by gently pulling it out to seal the gap.
Door Alignment
1. Remove the top hinge cover by using a flathead screwdriver. Place the head
under the front edge of the cap and gently lift.
2. Loosen the top hinge screws using a Phillips head screw driver.
3. Adjust the door or put a spacer in between and tighten the screws.
4. Replace the top hinge cover by aligning the rear of the cover with the rear of
the hinge. Press firmly on the front of the cover until it snaps in place.
Hole Plugs
Cover
Screws
Top Hinge
Lower
Hinge
Screws
Door Axis
Hole Cover
5