ENG-FRM-RIC-4.32, Rev. E
Technical Data Sheet
HBH550
PROPRIETARY RIGHTS NOTICE
This document and all information contained within it is the property of Hamilton Beach Brands, Inc. (HBB). It is confidential and
proprietary and has been provided to you for a limited purpose. It must be returned or destroyed upon request. Disclosure, reproduction or use of this document
and any information contained within it, in full or in part, for any purpose is forbidden without the prior written consent of HBB. No photographs may be taken of any
article fabricated or assembled from this document without the prior written consent of HBB.
Replacing the Oval Vacuum Chamber Seals:
1.
Turn “OFF” (
0
) the Vacuum Sealer and unplug from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the Vacuum chamber lid.
4. Pull the Oval Vacuum Chamber Seal out from its seating channel on the underside of the Vacuum
chamber lid.
5. Place the new seal into the seating channel then firmly compress the seal against itself as you press the
seal into the channel of the Vacuum Chamber lid.
6. Repeat process for the Vacuum Chamber Lower Seal
Replacing the Lower(15mm) Seal Bar Tape:
1.
Turn “OFF” (
0
) the Vacuum Sealer and unplug from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the Vacuum chamber lid.
4. Lift up and pull to remove the 15 MM Seal Bar Tape covering the Seal Bar Heating Element.
5. Remove the backing from the new 15 MM Seal Bar Tape.
Caution:
Do not allow the tape to contact anything while the adhesive is exposed.
6. Place the edge of the tape on the left-outermost edge of the vacuum chamber then press down on the
tape and slide your finger to the right, making sure there are no wrinkles or folds in the Seal Bar Tape.
Make sure the Seal Bar Heating Element is completely covered by the tape.
Replacing the Upper (10 MM) Seal Bar Tape:
1.
Turn “OFF” (
0
) the Vacuum Sealer and unplug from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the Vacuum chamber lid.
4. Lift and pull the 10 MM Seal Bar Tape covering the upper seal.
5. Remove the backing from the new 10 MM Seal Bar Tape
Caution:
Do not allow the tape to contact anything while the adhesive is exposed.
6. Place the tape on the left edge of the seal then press and slide your finger to the right making sure
there are no wrinkles or folds in the Seal Bar Tape.
4421 Waterfront Drive
Glen Allen, VA 23060
Revision Description:
Request Number:
Revision Date:
Approved by:
Issue Code(s):
Page:
4
of
6
Document #:
Rev:
A
