Hamamatsu Photonics C9100-02, Инструкция по эксплуатации

Страница: 6 / 30

C9100-02 Ver.1.7
2. CHECK THE CONTENTS OF PACKAGE
When you open the package, check that the following items are included before use. If the
contents are incorrect, insufficient, or damaged in any way, contact Hamamatsu
subsidiary or local distributor without attempting to operate the camera.
C9100-02 camera 1
Lens mount cap (attached to the camera) 1
Camera mount 1
C9100-02 instruction manual (this booklet) 1
[Option]
AC adaptor
(The accessories: Power supply Cord)
A3472-07
Camera cable (5 m) A9189-05
CameraLink interface cable (5 m) A9262-05
Note
•
The cable listed in option is highly recommended for use with
C9100 the camera. The camera system may not confirm to CE
marking regulation if other type of cable is used with.
3. INSTALLATION
Avoid using or storing this camera in the following places
• Where the ambient temperature might fall below 0
°
C or rise above 40
°
C
• Where the temperature varies extremely
• In direct sunlight or near a heater
• Where the humidity is 70 % or more or where there is dripping water
• Close to a strong source of magnetism or radio waves
• Where there is vibration
• Where it might come into contact with corrosive gases (such as chlorine or
fluorine)
• Where there is a lot of dust
Do not block ventilation openings
To prevent excessive internal temperature do not wrap cloth around
the equipment while it is in operation. Make sure the blowholes on
the side panels are not blocked. The blowholes must be at least 10
cm from the wall.
4