C11440-36U Instruction Manual Ver.1.1
11
③
Power switch [POWER]
The power is turned on/off.
When the power switch is pressed once, the camera is powered on and the lamp color stays in
green.
When the camera transfers data and the lamp color is orange.
When the power switch is pressed once again, the camera returns to the power off state and
the lamp turns off.
④
DC power input connector [DC IN]
This is the power supply terminal. Use the accessory AC adapter.
⑤
Timing out connector [TIMING]
This is used when peripheral device(s) require synchronization with the camera.
Output is 3.3 V LVCMOS level, and it is output though BUS TRANSCEIVER IC
“SN74LVC541APW”.
Output impedance is 33 Ω.
⑥
Trigger input connector [EXT.TRIG]
This is used when the camera is being operated using external synchronization.
Input is 3.3 V LVCMOS level, and input impedance is 10 k
Ω
.
When External trigger is input, the trigger is activated at the falling or rising edge of the signal.
(External trigger polarity is selectable between Negative and Positive.)
⑦
USB 3.0 interface connector [USB 3.0]
This is connected to the USB 3.0 interface connector on the computer.
•
When the USB 3.0 cable is connected, the application software must be closed
and the camera must be turned off.
⑧
Air outlet
This is the outlet for the heat ventilation.
•
To prevent overheating inside the camera, do not wrap the camera in cloth or
other material, or block the camera’s ventilation.
⑨
Mounting screw hole
This is the screw hole for fixing the camera to a tripod or other fixture.
•
When fitting the camera to a tripod or other fixture, be careful that the fitting
screw does not enter more than 8 mm. Screwing it in excessively can be
damaged the camera.
Содержание C11440-36U
Страница 2: ...Blank page...
