Hamamatsu Photonics C11440-22C, Инструкция пользователя

Страница: 15 / 51

C11440-22C Instruction manual_Ver.1.4
13
⑤
Trigger input connector [EXT.TRIG]
This is used when the camera is being operated using external synchronization.
Input is 3.3 V LVCMOS level, and input impedance is 10 k
Ω .
When an external trigger is input, the trigger is activated at the falling or rising edge of the
signal. (You can choose external trigger polarity between Negative and Positive.)
⑥
Timing out connector 1,2,3 [TIMING 1,2,3]
This is used when peripheral device(s) require synchronization with the camera.
Output is 3.3 V LVCMOS level, and it is output though BUS TRANSCEIVER IC
SN74AVC8T245. Output impedance is 33
Ω .
Note
•
Determine termination according to cable length and so on.
⑦
STATUS lamp [STATUS]
The LED indicates status of camera.
Lighting color Status of power distribution
Turn off (no color) Power off
Green (lighting)
Power on
Orange (lighting) Data transfer
Red (lighting) Heat up
Orange or Green
(blinking) Cooler progressing
(in Standard air-cooling mode )
CAUT ION
•
When the camera heats up, stop operation and unplug the AC
adaptor immediately.
⑧
Power switch [POWER]
The power is turned on/off.
When the power switch is set to "ON", the camera turns on and the lamp color is green.
When the camera transfers data and the lamp color is orange.
When the power switch is set to "OFF", the camera returns to the power off state and the lamp
turns off.
⑨
DC power input connector [DC IN]
This is the power supply terminal. Use the accessory AC adaptor.
⑩
USB connector [USB3.0]
•
This is not used with the camera. Do not connect it.
⑪
Air outlet
This is the outlet for the heat ventilation.
•
To prevent overheating in the camera’s interior, do not wrap the camera in
cloth or other material, or in any way allow the camera’s ventilation ports to
become blocked.
•
If the camera is being operated in an enclosed environment, ensure clearance
of at least 2 cm from both the intake and exhaust vents when setting up.