11
12
wearing on the left ear
wearing on the right ear
Wearing the headset
Charging the headset
Before using the headset for the fi rst time, charge the headset with the supplied power supply unit for at least
3 hours. Normal charging time after the fi rst charge is 3 hours.
- Plug the charger in to the mains power supply and connect it to the socket on the headset.
- The integrated LED lights red during the charging process. The LED switches off when the headset battery is
fully charged.
- Please note that charging may not begin immediately if the headset has not been used for an extended period!
- The LED fl ashes red to indicate that the battery is low. An audible signal (once a minute) also indicates this.
When this is the case, the headset must be charged as described.
Switching on/off the headset
- Press and hold the “MFB” button for 2 seconds to switch on the headset. The blue LED on the headset then
fl ashes 3 times in quick succession, and then regularly approx. every 4 seconds. An audible signal can also be
heard in the headset indicating that it has been activated.
- Press the “MFB” button for 5 seconds to switch off the headset. The blue LED on the headset then fl ashes 3
times in quick succession, and then goes out. An audible signal can also be heard in the headset indicating
that it has been deactivated.
Adjusting the headset to your mobile phone (pairing)
You must introduce both components to enable the headset to communicate with your telephone. This process
is known as pairing or coupling and is the basis for using the Bluetooth headset. Pairing only has to be carried
out once before the headset is commissioned for the fi rst time! Ensure that the headset is fully charged and the
power supply is not plugged into the headset. Prepare your telephone for the pairing process.
Follow the instructions in the operating manual of your mobile phone to switch your telephone to Bluetooth mode
and initiate and perform the coupling procedure.
- Ensure that the headset is switched off.
- Press the “MFB” button on the headset for approx. 7 seconds until the LED starts fl ashing red and blue
alternately. 1 second until the LED starts fl ashing red and blue alternately. Please note: The headset
maintains the pairing mode for 1 minute. After this time, it must be started again as described!
- Start pairing with your mobile phone as described in the instruction manual for your telephone. Follow the
instructions on your phone’s display.
- Your telephone searches for corresponding devices in the Bluetooth environment.
- If the headset fi nds your mobile phone, it will be indicated by “GBH-810”on the phone’s display.
00087510bda.indd Abs2:11-Abs2:12
00087510bda.indd Abs2:11-Abs2:12
06.03.2007 15:11:15 Uhr
06.03.2007 15:11:15 Uhr
