21
HAMA_DP2_UM-20151116-EN
5 OPERATION
EN
5.4.1 Assembly process for conversion from skim coat to plaster
1.
Check that there is still no pressure or power on the machine and that the emergency stop
is still pressed in as described in the dismantling steps.
2.
Remove the safety grill from the interior of the hopper.
3.
Remove the short shaft in the hopper, clean it with water and put it back in the machine.
4.
Next, position the stator together with the rotor that has been inserted in the machine.
5.
NOTE: the bayonet connection of the rotor must be on the same side as the yellow arrow
and lock bolt on the stator. Additionally, the terminal blocks of the Roza stator must point
up so that the prop of the machine falls precisely in between here.
6.
Insert your hand into the hopper and support the short shaft until the bayonet connection of
the shaft is connected to the rotor.
7.
Next, reinstall the safety grill in the hopper.
8.
Slide the sensor housing over the thread rods with the sensor cable on the left side and the
protruding catch on the machine side.
9.
Next, place the hard paper gasket against the sensor housing and slide the plaster
nosepiece over the thread rods. Tighten the entire unit with the washers and nuts with a
torque of 30 Nm.
10.
Next, tighten the clamps of the Roza stator equally until 60 bar is reached. Next, tighten the
lock bolt.
11.
Next, mount the aggregate hose on the machine
After removing the pump, we recommend that the rotor of the stator
be turned and both parts be cleaned and maintained well. If this is
not done, both parts could get stuck because of plaster residue and
become unusable!
ATTENTION
