14
HAMA_DP2_UM-20151116-EN
EN
5 OPERATION
5.1 Operation of plaster sprayers
1.
Remove the lid from the hopper and fill the hopper with spray aggregate.
2.
If a wringer is used, follow the following steps:
HAMA wringer:
a.
Place the bag on the wringer
b.
Position the handle of the bag between the rollers
c.
Put pressure on the bag
d.
Cut open the bottom with a knife
e.
Turn the handle of the wringer
f.
The aggregate will be deposited in the centre of the hopper
g.
Clean the wringer well after use
Washing machine wringer:
a.
Place the bag between the rollers
b.
Cut open the bottom with a knife
c.
Turn the handle of the wringer
d.
The aggregate will be deposited in the hopper
e.
Clean the wringer well after use
3.
Attach the required hose and spray gun without nozzle and connect the air hose.
4.
Make sure that the gun is closed..
5.
Open the protective cover of the motor and position the V-belt on the smallest pulley of
the motor and the largest pulley of the gearbox and close the protective cover again. This
step is necessary to allow the rubber in the stator to arrive at the correct operating
temperature.
6.
The pressure regulation button is on the left side of the machine. This must be set to zero.
The button for the rotation direction is on the same side. The legend under this button may
differ per machine::
Older machines
Current machines
The rotation direction must be set to “0” or “OFF”.
-1
0
1
Return
Off
On
If the HAMA Duo-Power 2.0 is used in combination with the HAMA
H455 compressor or another equivalent compressor, each machine
must be connected to a separate fuse group of 16 A.
