2
G
Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for future reference.
If you sell the device, please pass these operating instructions on to the new
owner.
1. Controls and displays
1. Air intake opening (both sides)
2. Air sensor
3. Air outlet opening
4. Display and operating display
5. Front panel
6.
Top speed
button:
On/Off of the maximum fan speed
7.
Anion
button:
Ion Generator On/Off - An ion generator produces negatively charged
ions (anions) and small amounts of ozone. This increases the
purification performance, as the anions combine with positively charged
dirt particles in the room air to form larger clusters. These can then be
filtered out more easily by the internal filters.
Warning - Ozone
Do not use this function if you are sensitive to ozone, in bedrooms, in
rooms where children are present and in rooms with tobacco smoke.
Pets might also feel disturbed.
8.
Speed
button: Fan speed level 1 - 2 - 3
9.
Timer
button: Running time preselectable from 1 - 12 hours
10.
Mode
button: Switching between the operating modes:
Automatic - Sleep - Manual
11.
Auto
button: The device regulates the fan speed independently
according to the air quality
12.
Sleep
button: All displays except the
Sleep
display go out and the
device operates in whisper mode to allow undisturbed sleep.
13.
ON/OFF
button: After connecting the device to a power socket, the
ON/OFF
display flashes.
•
Touch the button to start the device in Top Speed mode - Select the
desired operating mode via the
Mode
button (10).
14. Control lights
Remove HCHO:
Cleaning for formaldehyde is active (always active)
Purify:
Cleaning for fine dust is active (always active)
Anion:
lights up when the anion function has been activated via
button (7)
Sleep:
lights up when Sleep mode (12) has been activated
Replace Filter:
filter change indicator. The air purifier calculates a
required filter change according to how long it has been used. The
change indicator then lights up. The filter should then be replaced to
ensure sufficient air purification.
•
With daily use, the combi-filter should be used up after approx. 6 - 12
months.
•
Since the filter contains all the collected pollutants, it should only
be changed outdoors and with appropriate care against contact
contamination (gloves/respiratory protection).
•
The filter is not washable.
•
An unpleasant odour during operation may indicate that filtered
substances are decomposing in the filter (e.g. bacteria) and it needs to
be replaced or ventilated in the sun.
•
Vacuum the filter and the inner housing every 1 to 2 months to remove
coarse dirt. Then place the filter outdoors in direct sunlight for approx.
3 hours to dry it and eliminate any bacteria, viruses etc. that may be
present through the UV rays.
•
Also hold the vacuum cleaner to the sensor opening (2) to clean it.
•
The filter can then possibly be reused. The filter must be replaced after
1 year at the latest. On the one hand, there is a risk that it will no
longer completely remove the particles mentioned from the air or that
the pollutant particles already in the filter will be released again. The
activated charcoal also loses its effect when unpacked.
•
Auto:
Automatic mode selected via the
Auto
button (11). The built-in
air quality sensor controls the fan speed.
15.
Reset
button: After changing the filter, reset the display by pressing the
Filter reset
button (15) on the remote control.
16. Displays
Speed:
Display of the set fan speed level
PM 2.5:
in µg/m³; display of measured fine dust particles with an
aerodynamic diameter Ø 2.5µm (0.5 to 3.5µm). Typical concentrations
in homes are 20 to 30 µg/m³.
Air Quality:
After switching on the device, the display flashes until
the sensor has warmed up. After that, the display visually shows the
indoor air quality.
Green
stands for good quality
Orange
stands for normal quality
Red
stands for inadequate quality
If the humidity in the room is very high, condensation can form on
the sensor and negatively affect the display and cause switching back
and forth in automatic mode. In this case, use the air purifier with the
manual speed setting.
Temp:
Display of the room air temperature
Timer:
Display of the running time preselected via the Timer button (9)
2. Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates a risk of electric shock from touching product parts
carrying hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention
to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
3. Package contents
•
1 air purifier
•
1 combi filter
•
1 remote control
•
These operating instructions
4. Safety instructions
•
The product is intended for private, non-commercial use only.
•
The product is intended only for use inside buildings.
•
Use the product only for the intended purpose.
•
Protect the product from dirt, moisture and overheating and use it in dry
rooms only.
•
Always pull directly on the plug when disconnecting the cable, never on
the cable itself.
•
Do not use the product in the immediate vicinity of heaters, other heat
sources or in direct sunlight.
•
As with all electrical products, this device should be kept out of the reach
of children.
•
Do not operate the product outside the power limits specified in the
technical data.
•
Do not use the product in areas in which electronic products are not
permitted.
•
Do not use the product in a damp environment and avoid splashing water.
