Hama 00040072, Руководство по эксплуатации

Страница: 6 / 132

4
5.1.1 Switch the device you wish to operate on.
5.1.2 Press the "SETUP" button until the LED lights up
continuously.
5.1.3 Use the device button to select the device to be
operated (e.g. TV). If the selection is successful,
the LED flashes once and then lights up
permanently.
5.1.4 Search the code list for the brand and type of the
device to be operated.
5.1.5 Enter the corresponding four-digit code using the
number buttons 0-9. The LED confirms the entry
of each digit with a short flash and goes out
after the fourth digit.
5.1.6 Then test the remote control and check whether
the desired functions can be controlled. It is
possible that the first code is not the most
suitable, and possibly not all functions are
available. In this case, try the next code
mentioned for the selected device type/brand
from the list.
Note
• A valid code is automatically saved.
• If the code is invalid, the LED flashes six times and
then goes out. Repeat steps 5.1.1 to 5.1.5, or use
another method to enter the code.
5.2 Manual code search
The universal remote control has an internal memory
that already contains up to 350 codes per device type for
the most common AV devices. You can go through these
codes until the device to be operated shows a response.
For example, the device to be operated switches off
("POWER" button) or changes channel ("CH+/CH-"
buttons).
5.2.1 Switch the device you wish to operate on.
5.2.2 Press the SETUP button until the LED lights up
permanently.
5.2.3 Use the device button to select the device to be
operated (e.g. TV). If the selection is successful,
the LED flashes once and then lights up
permanently.
5.2.4 Press the "POWER" or "CH+/CH-" button to scroll
through the preset codes until the device to be
operated shows a response.
5.2.5 Press "MUTE" to save the code and exit the code
search. The LED goes out.
5.2.6 Then test the remote control and check whether
the desired functions can be controlled. It is
possible that the first code found is not the
most suitable, and possibly not all functions are
available. In this case, repeat steps 5.2.1.–5.2.5.
The code search starts with the next code
following the last one saved.
Note
• A maximum of 350 codes of the most common
devices can be stored in the internal memory.
Due to the numerous AV devices available on
the market, it may happen that only the most
common main functions are available. If this is the
case, repeat steps 5.2.1 to 5.2.5 to find a more
compatible code. A code may not be available for
some specific device models.
5.3 Automatic code search
The automatic code search uses the same preset codes
as the manual code search (5.2). However, the universal
remote control automatically searches the codes until the
device to be operated shows a response. For example, the
device to be operated switches off ("POWER" button) or
changes channel ("CH+/CH-" buttons).
5.3.1 Switch the device you wish to operate on.
5.3.2 Press the "SETUP" button until the LED lights up
continuously.
5.3.3 Use the device button to select the device to be
operated (e.g. TV). If the selection is successful,
the LED flashes once and then lights up
permanently.
5.3.4 Press the "CH+/CH-" or "POWER" button to
start the automatic code search. The LED flashes
once and then lights up permanently. It takes 6
seconds for the universal remote control to start
the first search.