8
9
ADAPTOR HARNESS WIRING
PRO PLUG-IN ECU WIRING
Haltech
Platinum
Pro Plug-in ECU
WB
1
B
R
To Battery Ground
To Switched
+12V Supply
HT-130043
-4 Power Supply
DTM
HT-130040
Included able with
c
Platinum Pro Series
s
ECU
HT-130025
Cable
CAN
Spare CAN port can be used to daisy chain other
Haltech CAN devices. (iC-7, TCA, I/O Expander etc)
Wiring for Platinum Pro Plug-in ECU
Connect the Haltech CAN Wideband Controller directly
to a Haltech Platinum Series ECU using the included
DTM-4 Power supply cable and CAN cable DTM-4 to
DTM-4 in series with the DTM-4 to 8 pin Tyco CAN cable
provided with the ECU as shown below.
Connect the DTM-4 Power supply cable RED power
wire to a fused and switched 12 Volt source that has
Haltech WB1 connected to a Haltech Platinum Pro Plug-in ECU
HT-130043
-4 Power Supply
DTM
To Switched
+12V Supply
HT-130025
Cable
CAN
!
Do not 12v and
ground from the PNP
harness to the HT-130043
power supply cable as the
WB sensor may overload
the adapter box.
Haltech
Elite ECU
Spare CAN port can be used to daisy chain other
Haltech CAN devices. (iC-7, TCA, TMS etc)
HT-130051
(CAN plug for single connector ECU
Plug’n’Play kits only)
Wiring for Elite Plug’n’Play Adapter Harness
Connect the Haltech CAN Wideband Controller to a
Haltech Elite series ECU using the included DTM-4
Power supply cable and CAN cable DTM-4 to DTM-4 in
series as shown below.
Haltech WB1 connected to an Elite Series ECU with Plug’n’Play adapter.
Connect the DTM-4 Power supply cable RED power
wire to a fused and switched 12 Volt source that has
power at Key On and Key Start positions. Connect the
DTM-4 Power supply cable Black ground wire to a good
ground source.
power at Key On and Key Start positions. Connect the
DTM-4 Power supply cable Black ground wire to a good
ground source.
For ease of installation power and ground will be
available from the vehicle harness please refer to
your specific ECU’s Quick start guide for reference and
locations.
