Page 17
Regeneration Mode
Typically a system is set to regenerate at a time of low water usage. An example of a time
with low water usage is when a household is asleep. If there is a demand for water when the
system is regenerating, untreated water will be used.
When the system begins to regenerate, the display will change to include information about
the step of the regeneration process and the time remaining for that step to be completed. The system runs through the steps
au to mat i cal ly and will reset itself to provide treated water when the regeneration has been completed.
Manual Regeneration
Sometimes there is a need to regenerate the system sooner than when the system calls for it, usually referred to as manual
re gen er a tion. There may be a period of heavy water usage because of guests or a
heavy laundry day.
To initiate a manual regeneration at the preset delayed regeneration time, when
the
regeneration time option is set to “NORMAL” or “ on 0”, press and
release “REGEN”. The words “REGEN TO DAY” will fl ash on the display to
indicate that the system will re gen er ate at the preset delayed re gen er a tion time.
If you pressed the “REGEN” button in error, pressing the button again will cancel the request. Note: If the
regeneration time option is set to “on 0” there is no set delayed regeneration time so “REGEN TODAY” will
not activate if “REGEN” button is pressed.
To initiate a manual regeneration immediately, press and hold the “REGEN” button for three seconds. The system will begin to
regenerate immediately. The request cannot be cancelled.
Note: For softeners, if brine tank does not contain salt, fi ll with salt and wait at least two hours before regenerating.
Set Time of Day
The user can also set the time of day. Time of day should only need to be set after power outages lasting more than 8 hours, if the
Power Loss
If the power goes out, the system will keep time for up to 8 hours or until the battery is depleted. If a power outage of
more than 8 hours occurs, the time of day will fl ash on and off which indicates the time of day should be reset. The
system will remember the rest. If a power outage lasts less than 8 hours and the time of day fl ashes on and off, the non
rechargeable battery should be replaced.
Error Message
If the word “ERROR” and a number are alternately fl ashing on the display
contact the OEM for help. This indicates that the valve was not able to function properly.
battery has been depleted and a power outage occurs, or when daylight saving time begins or
ends. If a power outage lasting more than 8 hours occurs, the time of day will fl ash on and off
which indicates the time of day should be reset. If a power outage lasts less than 8 hours and
the time of day fl ashes on and off, the time of day should be reset and the battery replaced.
STEP 1U
– Press SET CLOCK.
STEP 2U
- Current Time (hour): Set the hour of the day using Down or Up buttons. AM/PM
toggles after 12. Press NEXT to go to step 3U.
STEP 3U
- Current Time (minutes): Set the minutes of the day using Down or Up buttons.
Press NEXT to exit Set Clock. Press REGEN to return to previous step.
STEP 1U
STEP 2U
STEP 3U
REGEN TODAY will
Flash if a regeneration
is expected “Tonight.”
