710-0133 HM 46 57 Hallmark Manual
Date: 06/24/16
Rev 04
Page 3 of 13
ROOM ASSEMBLY
The sauna rooms come in different sizes. These instructions are only for the 4x6 and 5x7
Hallmark Series rooms.
* Each panel is heavy. Be careful to avoid injury when installing, especially the top panel(s).
* Two adults are required for the installation of sauna room.
* There is a “+” button or a “–” button at the sides of each panel, which will be installed
correspondently with one “+” to one “–” in following way when installing: The panel with “+”
button should be lifted up about 1 inches (2.5cm) higher than the panel with the “-” button (Refer
to Picture 1); place the “+” panel against the panel with “–” button (Refer to Picture 2), and then
slide down the panel with “+” button until the two panels are equal in height (Refer to Picture 3).
If they are not equal in height or there is an obvious gap between the two panels, that means they
are not properly attached, and you should try again.
Typical room installation is as follows:
1.
Place floor/base panel on level surface. If not even, shim the base panel until level
2.
Place back right wall panel on floor/base panel
3.
Place right wall panel on floor/base panel then interlock to back panel
4.
Place left back wall panel on floor/base panel and interlock to right back panel
5.
Place left wall panel on floor/base panel and interlock to back left panel
6.
Place right front wall panel on floor/base panel and interlock with right side wall
7.
Place ceiling on top of all wall panels
8.
Install glass window and door.
Note:
The vents must be kept free from any obstruction so proper airflow is maintained in the
sauna room. Do not stack anything in front of the vents or push the room wall with vents up tight
to a wall surface.
