710-0133 HM 46 57 Hallmark Manual
Date: 06/24/16
Rev 04
Page 4 of 13
ROOM ASSEMBLY (CONT.)
Step 1: Place the floor panel in the desired
location on a level surface.
Note: The floor panel must be level before
installing the wall and ceiling panels. If the
surface is not level, you may need to shim the
floor/base panel to get level.
Step 2: Place the back panel and interlock the side
panels on to the back panel.
Step 3: Place the front panel on the room.
Step 4: Place the ceiling panel on the wall panels.
Note: Make sure the top panel’s front is facing the
front, that the trim of the top panel fits completely
around the walls and that the connection wires
fron the control panel wall protrude through the
hole of the ceiling panel. Be careful to not kink or
pinch the wires.
Step 5: Lift up the ceiling slightly and carefully
place glass section into groove on floor panel and
align with groove in ceiling panel. Lower the
ceiling down to lock the room.
Step 6: Connect the wires in the ceiling panel
accessed via flip-up panel as shown above
.
Note: Match each wire connection to the similar
corresponding connector
type.
