Programmable Serial Controller
15
Note
Storing and Recalling IR codes from memory locations are ONLY allowed
when the HR-4P unit is in the program mode. (The LED is BLINKING)
Figure 14 – IR Learn
Figure 15 – IR Send
3.18 Communications
•
The
Communications
tab page can be used to select a COM port of your PC
to talk to the HR-4P unit. Once, the preferred COM port is selected, pressing
the
Connect
button either in this tab page or on the left of the Main screen to
make a serial connection.
•
Since the HR-4P’s serial port communicates at a fix baud rate of 19200, no
parity, 1 stop bit, and 8 data bits, those drop-down selections will be disabled.
The COM port is the only selection that needs to be set as shown in Figure 16.
Figure 16 – Communications
