Installing the L-806 Wind Cone
Installing the Wind Sock to the Basket
After the basket has been attached to the top of the pole and any lighting kit
installed, you can install the wind sock by performing the following steps.
1.
Remove the wind sock from the shipping pallet.
2.
One end of the sock has eyelets, open this end and slide the sock over the
small end of the basket, see Figure 18.
3.
Slide the sock over the basket until the entire basket is covered, see
Figure 18.
4.
Remove the group of cable straps from the shipping pallet.
5.
Place a cable strap through each eyelet and around the basket frame.
6.
Tighten each cable strap and clip off any excess portion of each cable strap.
2
1
HBA109
Figure 18. Installing the Wind Sock
1. Wind Sock
2. Eyelets
7.
Inspect the entire assembly for nicks or other damage to painted surfaces.
Apply the supplied paint to these areas.
8.
Assemble the pole to the baseplate, see “Assembling the Pole to the Base-
plate” on page 35.
34
L-807 and L-806 Wind Cone Installation and Maintenance Manual