Installing the L-806 Wind Cone
Installing the External Lighting Kit
Install the external lighting kit by performing the following steps.
1.
Remove the external lighting kit from the pallet and place it on the ground near the top of
the basket.
2.
Remove cable straps, used for shipping, from the electrical cable.
3.
Push the wire cable through the basket support pipe, down through the pole, and out
the bottom, see Figure 16.
4.
Place anti-locking compound onto the threads at the top of the basket sup- port pipe, see
Figure 16. Make sure all threads have been covered thor- oughly.
5.
Tighten the lighting kit onto the basket support pipe.
6.
Refer to Figure 11. Remove the bolt, flat washer and lock washer from the upper bracket
attachment. Remove the nut, flat washer and lock washer from the lower bracket attachment.
Place the light support bracket on the upper and lower bracket attachment points as shown in
Figure 11, with the slotted end of the light support bracket towards the wind cone lamp.
Reinstall the upper bracket bolt and washers and the lower bracket nut and washer, but only
finger-tight.
7.
Tighten the fasteners on both ends of the light support bracket, see Figure 11.
8.
Install the wind sock, see “Installing the Wind Sock to the Basket” on page 34.
1
2 3 4 5
6
Figure 16. Feeding the Electrical Cable
1. Place lights on ground
2. Feed end of cable into top of basket support pipe
3. Place anti-locking compound on threads
4. Pull cable through basket support pipe
5. Pull cable through pole
6. Pull excess cable out bottom of pole
HBA164R2
32
L-807 and L-806 Wind Cone Installation and Maintenance Manual