HALE SmartFOAM 1.7AHP, Описание, установка и руководство по эксплуатации

Страница: 42 / 93

Page 41
SmartFOAM
Figure 20 : Typical Reduced Size Sensor Piping Arrangement
Figure 21 : Flow Sensor Placement
SADDLE CLAMP INSALLATION
See Figure 22 : Flow Sensor/Saddle Clamp
Installation .
Installation of the paddlewheel flow sensor using a
saddle clamp requires a 1.385/1.390 inch (35/35.3 mm)
bored hole in the pipe.
A minimum of six times the pipe diameter of straight run
pipe without any fittings is necessary prior to the position
of this hole.
Figure 22 : Flow Sensor/Saddle Clamp Installation
The flow sensor requires a spacer and eight stainless
steel internal hex head screws. These are supplied with
the sensor.
Four 6-32 x1/2 inch screws attach the spacer to the
saddle clamp mount and four 6-32 x 3/4 inch screws with
lock washers attach the paddlewheel to the spacer.