DUAL DRYER SYSTEM
INSTALLATION/SERVICE
MANUAL (L31279)
®
GeminiMDx
1. Ensure air pressure is at 0 PSI in air system.
2. Disconnect air lines from GeminiMDx manifolds
and Consep inlet manifold.
3. Disconnect electrical connection from the Consep
ADV.
4. Disconnect the electrical connection from both
heating elements.
5. Remove the mounting bolts from the GeminiMDx
bracket.
6. Remove the air dryer for inspection and
maintenance.
7. Reinstall / install the unit to the mounting location
using the mounting bolts. Tighten and torque the
bolts to 35-50 ft-lbs
8. Connect electrical plugs to both heating elements.
9. Connect electrical plugs to the Consep ADV.
Valve (ADV) electrical harness.
10. Reconnect air lines to the GeminiMDx manifolds
and Consep inlet manifold.
Perform Operational Checks (Page 12).
NOTE: Clean area above and around the GeminiMDx
BEFORE removing the cartridge canister.
Cartridge Canister
1. Ensure air pressure is at 0 PSI in air system.
2. Clean and remove all debris around cartridge
canister.
3. Remove four retaining bolts from retaining
collar.
4. Lift cartridge canister away from dryer base.
5. Inspect and remove any debris from dryer base.
Discard old o-rings and clean sealing surface.
6. Ensure that protection cap for safety valve housing
is not damaged. If cap is off, snap cap back into
place.
7. Flip cartridge canister upside down. Rotate
desiccant cartridge 45° and remove from canister.
8. Install desiccant cartridge into canister and rotate
45° to secure the cartridge to the canister.
Removal/Installation Instructions
Page 18
Содержание GeminiMDx
Страница 1: ...INSTALLATION SERVICE MANUAL High Capacity Dual Dryer System...
Страница 27: ...inside back cover blank...