06-7182-01.fm
101
Attachments/options
6.4.2
Check and correct settings
If the pre-sweep suction unit is attached to the machine and the lever is in the
sweeping position (Pos. 1)
Fig. 61-A
, the frame must be aligned parallel to
the floor.
If this is not the case, the following steps must be taken:
1. Disconnect the pre-sweep suction unit.
2. Unscrew the swivel bracket
from the machine. The tilt angle of
the frame is determined by adding or removing the washers
. The
following applies: the more the washers are used, the more the frame will
tilt downwards at the front.
Fig. 62:
B
=
A
With overhead guard
Without overhead guard
